Important User Information Solid state equipment has operational characteristics differing from those of electromechanical equipment. Because of this difference, and also because of the wide variety of uses for solid state equipment, all persons responsible for applying this equipment must satisfy themselves that each intended application of this equipment is acceptable. In no event will Rockwell Automation, Inc. The examples and diagrams in this manual are included solely for illustrative purposes. Because of the many variables and requirements associated with any particular installation, Rockwell Automation, Inc.
|Genre:||Health and Food|
|Published (Last):||20 May 2009|
|PDF File Size:||20.44 Mb|
|ePub File Size:||11.67 Mb|
|Price:||Free* [*Free Regsitration Required]|
If you are using RSLogix software, version 11 or higher, you can also use the modules with ControlNet and Ethernet adapters. Use this diagram to identify the external features of the module. They install on mounting bases that mount on a DIN rail.
Make sure that the mounting base is correctly keyed before installing the module into the mounting base. In addition, make sure the mounting base locking screw is positioned horizontal referenced to the base.
This could cause an explosion in hazardous location installations. This allows the mounting base to be removed and replaced as necessary without removing any of the wiring.
To insert the Removable Terminal Block, proceed as follows: 1. Insert the end opposite the handle into the base unit. This end has a curved section that engages with the wiring base. Rotate the terminal block into the wiring base until it locks itself in place.
Remove the Removable Terminal Block, if wired. Press on the module lock on the top of the module. Repeat steps 1, 2, 3 and 4 for the module to the right. Be sure that power is removed or the area is nonhazardous before proceeding.
1734-OB8 POINT I/O 8 POINT DIGITAL OUTPU
POINT I/O™ 24V DC-Ausgangsmodul
Allen-Bradley 1734-OB8E PLC 8 Point 24V DC Digital Output Module